ISRO ICRB Scientist/Engineer 'SC' Computer Science & Engineering ICRB Pattern

ISRO Scientist/Engineer CS Solved Papers

Prepare for ISRO ICRB examinations with verified solutions covering Algorithms, Theory of Computation, Compiler Design, Computer Architecture, OS, Discrete Mathematics, and Computer Networks.

0%
Score Tracker
Live accuracy rate
0
Correct
0
Wrong
0
Attempted
Filter ISRO Computer Science Questions

All ISRO CS PYQs / All CS Subjects / All Topics

Marking scheme: +3.00 positive, -0.75 negative (ICRB Standard).

989 Questions Page 40 of 40
976

What is the division factor of the following clock divider circuit?

DQQ'DQQ'CLK INCLK_OUT
ISRO Scientist/Engineer 'SC' Electronics 2013 Digital Electronics
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the step-by-step solution.
Detailed Solution & Analysis
977

For the circuit given below, the voltage Vo across the op-amp output is:

Vi100500100100−+Vo
ISRO Scientist/Engineer 'SC' Electronics 2013 Analog Circuits
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the step-by-step solution.
Detailed Solution & Analysis
978

The rms value of current $i(t) = I_1\sin\omega t + I_2\sin 2\omega t$ is:

ISRO Scientist/Engineer 'SC' Electronics 2013 Electrical Engineering
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the step-by-step solution.
Detailed Solution & Analysis
979

Given the output for the following non-inverting summing amplifier, the relation between Rf and R in the circuit is:
$$V_o = \{V_1 + V_2 + V_3 + V_4\} / 2$$

RV1RV2RV3RV4−+RRfVo
ISRO Scientist/Engineer 'SC' Electronics 2013 Analog Circuits
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the step-by-step solution.
Detailed Solution & Analysis
980

A pulse signal having 100 kHz frequency and 70 nsec rise time is to be measured on an oscilloscope. The minimum required bandwidth of the oscilloscope is,

ISRO Scientist/Engineer 'SC' Electronics 2013 Electronic Instrumentation
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the step-by-step solution.
Detailed Solution & Analysis
981

Multiple collectors are used in Traveling Wave Tube (TWT) to:

ISRO Scientist/Engineer 'SC' Electronics 2013 Microwave Engineering
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the step-by-step solution.
Detailed Solution & Analysis
982

A lossless antenna has directional gain $G(\theta,\phi)$, then $\int_{\phi=-\pi/2}^{\pi/2}\int_{\theta=-\pi/2}^{\pi/2} G(\theta,\phi)\,d\Omega$ is :

ZXYG(θ,φ)θφ
ISRO Scientist/Engineer 'SC' Electronics 2013 Antenna Theory
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the step-by-step solution.
Detailed Solution & Analysis
983

$\sqrt[3]{\cos x - j\sin x}$ is equal to

ISRO Scientist/Engineer 'SC' Electronics 2013 Engineering Mathematics
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the step-by-step solution.
Detailed Solution & Analysis
984

If $f(t)$ is 1 MHz sinusoid with 1 Vp-p and sampling frequency fs is 25KHz, the output will be :

f(t)8 bitA/D88 bitD/AOutputfs, Sampling Frequency
ISRO Scientist/Engineer 'SC' Electronics 2013 Communications Engineering
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the step-by-step solution.
Detailed Solution & Analysis
985

For a practical low pass filter, the ideal amplitude and phase response will be :

ISRO Scientist/Engineer 'SC' Electronics 2013 Signals Systems
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the step-by-step solution.
Detailed Solution & Analysis
986

A 10dB attenuator is put at the input of a low noise amplifier having 3dB noise figure. Now the noise figure of the cascaded amplifier will be

ISRO Scientist/Engineer 'SC' Electronics 2013 Communications Engineering
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the step-by-step solution.
Detailed Solution & Analysis
987

A 33.33% duty cycle rectangular wave is fed to the input of an Spectrum Analyzer. What will be observed?

ISRO Scientist/Engineer 'SC' Electronics 2013 Signals Systems
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the step-by-step solution.
Detailed Solution & Analysis
988

Phase function of a filter is $\phi(f) = k f^2$, $k > 0$. The group delay of the filter has the shape

ISRO Scientist/Engineer 'SC' Electronics 2013 Signals Systems
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the step-by-step solution.
Detailed Solution & Analysis
989

1V p-p sinusoid is digitized by a 4 bit A-to-D converter with input dynamic range of 2V p-p. The signal to noise ratio of the digitized signal is:

ISRO Scientist/Engineer 'SC' Electronics 2013 Communications Engineering
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the step-by-step solution.
Detailed Solution & Analysis