ISRO ICRB Scientist/Engineer 'SC' Electronics & Communication (ECE) ICRB Pattern

ISRO Scientist/Engineer ECE Solved Papers

Practice previous years' questions for Electromagnetics, Antennas, Microwave Engineering, Digital Communication, Signals & Systems, Analog Electronics, VLSI, and Optical Communications.

0%
Score Tracker
Live accuracy rate
0
Correct
0
Wrong
0
Attempted
Filter ISRO Electronics Questions

All ISRO ECE PYQs / All ECE Subjects / All Topics

Marking scheme: +3.00 positive, -0.75 negative (ICRB Standard).

495 Questions Page 18 of 20
426

Two ideal quantizers A and B have following specifications:
A: 5 bit Quantizer with input dynamic range of -1V to +1V with Q1 as quantization noise power
B: 8 bit Quantizer with input dynamic range of -0.5V to +0.5V with Q2 as quantization noise power.
Then Q1/Q2 will be

ISRO Scientist/Engineer 'SC' Electronics 2013 Communications Engineering
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
427

The divergence of magnetic field intensity is

ISRO Scientist/Engineer 'SC' Electronics 2013 Electromagnetic Fields
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
428

A UART is configured to transmit 8 bit data, 1 start bit and 1 stop bit. The serial data output is observed on oscilloscope, which looks like a square wave with frequency of 9600 Hz. What is the baud rate and transmitted data?

ISRO Scientist/Engineer 'SC' Electronics 2013 Microprocessors Microcontrollers
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
429

A transmission line having characteristic impedance of 50ohms has to deliver 10KW power at 100KHz to a load. Maximum permissible value of rms current anywhere along the line is 20A. What is the maximum VSWR that can be tolerated on this line?

ISRO Scientist/Engineer 'SC' Electronics 2013 Transmission Lines
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
430

Routh Hurwitz criterion is used to determine

ISRO Scientist/Engineer 'SC' Electronics 2013 Control Systems
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
431

The decoding circuit shown in the figure is has been used to generate active low chip select signal of memory interfaced to 8 bit microprocessor with 16 bit address bus. What is address range and size of memory?

A15A14A13A12-CS
ISRO Scientist/Engineer 'SC' Electronics 2013 Microprocessors Microcontrollers
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
432

If the waveguide cross-section of a square waveguide with TE11 propagation mode is gradually deformed into a circle, then the corresponding circular waveguide mode will be:

ISRO Scientist/Engineer 'SC' Electronics 2013 Microwave Engineering
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
433

What could be the output current rating of following shunt regulator?

+10V50Ω5V0.4WVo
ISRO Scientist/Engineer 'SC' Electronics 2013 Electronic Devices
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
434

An FM-CW (Frequency Modulated - Continuous Wave) Radar is essentially

ISRO Scientist/Engineer 'SC' Electronics 2013 Radar Engineering
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
435

The flux in a magnetic core is sinusoidally varying at 200 Hz. The maximum flux density is 2 Tesla and eddy current loss is 15 W. If the frequency is raised to 400 Hz and maximum flux density reduced to 1 Tesla, the eddy current loss will

ISRO Scientist/Engineer 'SC' Electronics 2013 Electrical Engineering
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
436

The electric field intensity E and magnetic field intensity H are coupled and propagating in free space in x and y direction respectively, the Poynting vector is given by

ISRO Scientist/Engineer 'SC' Electronics 2013 Electromagnetic Fields
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
437

If x and y are two random signals with zero mean Gaussian distribution having identical standard deviation, the phase angle between them is

ISRO Scientist/Engineer 'SC' Electronics 2013 Probability Theory
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
438

The current flowing through a capacitor in an AC circuit is:

ISRO Scientist/Engineer 'SC' Electronics 2013 Electromagnetic Fields
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
439

Which of the following is the Boolean function for Majority Voting, assuming A,B,C are inputs and Y is output?

ISRO Scientist/Engineer 'SC' Electronics 2013 Digital Electronics
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
440

For broadside antenna array, the largest possible spacing between the antenna elements without any grating lobes is

ISRO Scientist/Engineer 'SC' Electronics 2013 Antenna Theory
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
441

For the 8085 assembly language program given below, the content of the accumulator after the execution of the program is
3000 MVI A, 45H
3002 MOV B, A
3003 STC
3004 CMC
3005 RAR
3006 XRA B

ISRO Scientist/Engineer 'SC' Electronics 2013 Microprocessors Microcontrollers
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
442

Conduction angle of a Class AB amplifier is:

ISRO Scientist/Engineer 'SC' Electronics 2013 Analog Circuits
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
443

For non dispersive medium

ISRO Scientist/Engineer 'SC' Electronics 2013 Electromagnetic Fields
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
444

Schottky clamping is resorted in TTL gates

ISRO Scientist/Engineer 'SC' Electronics 2013 Digital Electronics
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
445

At cut-off frequency, the phase velocity of a waveguide is

ISRO Scientist/Engineer 'SC' Electronics 2013 Microwave Engineering
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
446

Zener diode, when used in voltage stabilization circuits, is biased in

ISRO Scientist/Engineer 'SC' Electronics 2013 Electronic Devices
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
447

The closed loop frequency response of a dc-dc converter is shown in following figure. What are the gain and phase margins?

Gain (dB)Phase (Degree)3018020120106000-10-60-20-120-30-180GainPhase
ISRO Scientist/Engineer 'SC' Electronics 2013 Control Systems
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
448

If for a silicon npn transistor, the base-to-emitter voltage (VBE) is 0.7V and the collector-to-base voltage (VCB) is 0.2 V, then the transistor is operating in the

ISRO Scientist/Engineer 'SC' Electronics 2013 Electronic Devices
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
449

3 port Circulator is

ISRO Scientist/Engineer 'SC' Electronics 2013 Microwave Engineering
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation
450

An 8 bit ripple counter and an 8 bit synchronous counter are made using flip flops having a propagation delay of 10 ns each. If the worst case delay in the ripple counter and the synchronous counter be R and S respectively, then

ISRO Scientist/Engineer 'SC' Electronics 2013 Digital Electronics
Technical Evaluation
Click an option to evaluate
Select an option on the left to reveal the detailed solution.
Detailed Engineering Derivation