Prepare for the RRB Assistant Loco Pilot (ALP) Stage 2 Examination with official previous years' solved question papers across Part A (Mathematics, Basic Science & Engineering, General Intelligence & Reasoning) and Part B (Qualifying Trade Test — ITI/NCVT Fitter: Hand Tools, Measuring Instruments, Limits, Fits & Tolerances, Fasteners, Drilling, Pipe Fitting, Lathe Operations, Heat Treatment, and Railway Workshop Safety).
Marking pattern: Part A (100 Qs / 100 Marks) & Part B Trade (75 Qs / 75 Marks, Qualifying 35%); +1.00 positive, -0.33 (1/3rd) negative marking (Official RRB Scheme).
In thread cutting, 'BSW' stands for:
Which of the following organisations is responsible for enforcing workplace safety regulations in India?
What is the purpose of hammering during normalising?
_________ type of lapping is used for precision finishing of engine cylinder bores.
If the current flowing through a conductor is 5 A and the resistance of the conductor is 10 ohms, what will be the voltage across the conductor, according to Ohm's Law?
Gaskets, seals and spacers are made using:
When the size of the shaft or male part of a job is more than hole or female part, the difference between the two will be known as:
A drawing instrument box is used to carry all _________ instruments.
What is the purpose of a split die in pipe threading?
Which of the following types of pliers is used to shape loops in wires and to form curves in light metal strips?
Non-functional dimensions are:
Which of the following is NOT a failure mode of ball bearings?
After heating, how should the workpiece be cooled in the normalising process?
Toughness is the ability of a material to:
What does 'charging' of a lapping tool mean?
The unit for specific gravity is:
What is the main advantage of using MOSFETs in electronic circuits compared to other types of transistors?
Silicon carbide as a honing abrasive is best suited for which type of material?
Which hardness test uses a diamond pyramid-shaped indenter?
In a forward Vernier scale, the size of one Vernier scale division is:
In a velocity-time graph, the negative slope represents:
What should you do to ensure your personal safety at work?
When using a multimeter to measure current, which of the following is correct?
Which of the following is an important safety measure during a power failure?
Which of the following tools is NOT under the requirement to complete the Step Turning Process?