Prepare for UPSC Indian Engineering Services (IES/ESE) with official previous years' questions, detailed derivations, phasor analysis, and circuit solutions across Electrical Machines, Power Systems, Control Systems, Power Electronics, Network Theory, and Analog & Digital Circuits.
Marking pattern: +2.00 positive, -0.66 negative (Official UPSC ESE 1/3rd Negative Marking Scheme; 150 Questions, 300 Marks).
A set of independent current measurements is recorded as 10-03 A, 10-10 A, 10-11 A and 10-08 A. What are the values of average current and range of error respectively?
During the measurement of low resistance using a potentiometer, the following readings were obtained:
The voltage drop across the low resistance under test = 0-4221 V
The voltage drop across a $0\cdot 1\,\Omega$ standard resistance = 1-0235 V
What are the values of unknown resistance and current respectively?
The coil of a moving-coil voltmeter is 40 mm long and 30 mm wide, and has 100 turns on it. The control spring exerts a torque of $240\times 10^{-6}\text{ N-m}$ when the deflection is 100 divisions on full scale. If the flux density of the magnetic field in the air gap is $1\cdot 0\text{ Wb/m}^2$, what is the value of the resistance that must be put in series with the coil to give one volt per division by neglecting the resistance of the voltmeter coil?
Which one of the following statements is correct regarding moving-iron instrument when voltages or currents are measured?
A moving-coil instrument gives a full-scale deflection of 10 mA, when the potential difference across its terminals is 100 mV. What is the value of shunt resistance for a full-scale deflection corresponding to 100 A?
The power in a three-phase circuit is measured with the help of 2 wattmeters. The reading of one of the wattmeters is positive and that of the other is negative. The magnitudes of readings are different. What is the value of the power factor of the circuit under this condition?
What is the range of frequency measured by the typical frequency meter?
A $3\frac{1}{2}\text{-digit}$ DVM has an accuracy specification of ± 0.5 percent of reading ± 1 digit. What is the possible error in volt, when the instrument is reading 5.00 V on the 10 V range?
Which one of the following statements is correct regarding potentiometric recorders?
If the bandwidth of an oscilloscope is given as direct current to 10 MHz, what is the fastest rise time a sine wave can have to be accurately reproduced by the instrument?
What is the key factor that must be considered while selecting a transducer for a particular application?
If a transducer has an output impedance of $1\,\Omega$ and a load resistance of $1\text{ k}\Omega$, it behaves as
If a 50 Hz, 220/400 V, 50 kVA, single-phase transformer operates on 220 V, 40 Hz supply with secondary winding, then what about the core losses of the transformer?
An 1100/415 V, delta-star transformer feeds power to a 30 kW, 415 V, three-phase induction motor having an efficiency of 90% and full-load p.f. 0-833. What are the rating of the transformer and line current of low-voltage side respectively?
The kVA rating of an ordinary two-winding transformer increases when connected as an autotransformer because
The lap-connected armature winding is suitable for
Which one of the following statements is not correct regarding interpoles of DC machines?
A DC series motor, running a fan at 1000 r.p.m., takes 50 A from 250 V mains. The armature plus field resistance is $0\cdot 6\,\Omega$. If an additional resistance of $4\cdot 4\,\Omega$ is inserted in series with the armature circuit, what is the value of the motor speed when the field flux is proportional to the armature current?
A three-phase, 60 Hz, 25 hp, wye-connected induction motor operates at a shaft speed of almost 1800 r.p.m. at no load and 1650 r.p.m. at full load. What are the values of speed of the rotor field with respect to the rotor itself and with respect to the stator field respectively?
The rotor input of a three-phase induction motor running with a slip of 10% is 100 kW. What is the value of the gross power developed by the rotor?
What is the value of percentage voltage regulation of an alternator having 0.75 leading power factor loads, when the no-load induced e.m.f. is 2400 V and the rated terminal voltage is 3000 V?
Two identical alternators are running in parallel and carry equal loads. What will happen if the excitation of one alternator is increased without changing its steam supply?
A synchronous motor connected to infinite bus-bar has, at constant full load, 100% excitation and unity power factor. When there is a change in excitation only, the armature current will have
What are the values of maximum step rate for permanent-magnet and variable-reluctance stepper motors respectively?
Consider the following statements regarding ideal transformer:
Which of the above statements is/are not correct?