Prepare for UPSC Indian Engineering Services (IES/ESE) with official previous years' questions, detailed derivations, phasor analysis, and circuit solutions across Electrical Machines, Power Systems, Control Systems, Power Electronics, Network Theory, and Analog & Digital Circuits.
Marking pattern: +2.00 positive, -0.66 negative (Official UPSC ESE 1/3rd Negative Marking Scheme; 150 Questions, 300 Marks).
What is the final value of the function $f(t)=e^{-2t}\sin 5t\,u(t)$?
If a discrete signal represented by $x(n)=\alpha^{n}u(n)$ then what is the value of the signal $g(n)=x(n)-\alpha x(n-1)$?
For an amplitude modulated double sideband full carrier wave, a peak unmodulated carrier voltage $V_{c}=10\text{ V}_{p}$, a load resistance $R_{L}=10\ \Omega$ and a modulation coefficient $m=1$. What is the total power of the modulated wave?
For a Citizens band receiver using high-side injection with an RF carrier of 27 MHz and an IF centre frequency of 455 kHz, what is the image frequency?
Which of the following statements are correct to improve the noise figure of a receiver?
Select the correct answer using the code given below.
Any device or circuit whose output is not a linear variation with the input can be used as
In the receiver parameter, fidelity is a measure of
Which one of the following statements is correct regarding tuned radio frequency receiver?
Which one of the following is a figure of merit used to indicate how much the signal-to-noise ratio deteriorates as a signal passes through a circuit or series of circuits?
Consider the following statements related to the source coding:
Which of the above statements are correct?
Consider the following statements regarding differential pulse-code modulator:
Select the correct statements using the code given below.
How many minimum number of samples are required to exactly describe the following signal?
$$x(t)=10\cos(6\pi t)+4\sin(8\pi t)$$
Which one of the following is not a property of a Gaussian random process?
A PCM system uses a uniform quantizer followed by a 7-bit binary encoder. The bit rate of the system is equal to $50\times10^{6}\text{ bits/sec}$. What is the maximum message signal bandwidth for which the system operates satisfactorily?
Statement (I): Aluminium oxidizes quickly in normal atmospheric conditions and acquires a thin film of oxide $\text{Al}_{2}\text{O}_{3}$.
Statement (II): The high melting point of aluminium oxide coating and the rapidity with which a freely exposed aluminium surface becomes oxidized, make soldering difficult through conventional means.
Statement (I): When the signal is of the form of current, then series input devices are used.
Statement (II): An ammeter, which is a series device, thus should be designed with a low input impedance so that the current is correctly measured.
Statement (I): If the gain margin is negative, this gives the decibel rise in open-loop gain, which is theoretically permissible without oscillation.
Statement (II): For a multistage amplifier, if the open-loop gain $|\beta A|$ is unity when the phase shift is $180^{\circ}$, then the closed-loop amplifier will oscillate.
Statement (I): When negative feedback is applied to the ideal amplifier, the differential input voltage is 0 (zero).
Statement (II): There is no current flow into either input terminal of the ideal op-amp.
Statement (I): When the carrier is generated by a crystal oscillator, the frequency is fixed by the crystal.
Statement (II): The equivalent circuit of a crystal is an L-C-R circuit with both series and parallel resonant points.
Statement (I): In FDM transmitter, if the signals which are to be multiplexed will each modulate a separate carrier, then the type of modulation can be AM, SSB, FM or PM.
Statement (II): In FDM transmitter, the modulator outputs will contain the sidebands of the corresponding signals.