Prepare for UPSC Indian Engineering Services (IES/ESE) with verified solutions across Analog & Digital Communications, VLSI & Semiconductor Devices, Signals & Systems, Electromagnetics & Antennas, Microwave Engineering, Control Systems, Computer Organization, and Network Theory.
Marking pattern: +2.00 positive, -0.66 negative (Official UPSC ESE 1/3rd Negative Marking Scheme; 150 Questions, 300 Marks).
What is the value of voltage between points A and B of the network shown in the figure?
What is the value of voltage at node $V_A$ shown in the network below?
What is the value of resistance $R_L$ in the circuit shown in the figure to deliver maximum power from the source to load?
From the impedance triangle of an R-L series circuit fed with single-phase voltage, what is the value of power factor of the circuit?
A coil consists of 750 turns and a current of 10 A in the coil gives rise to a magnetic flux of $1200\;\mu\text{Wb}$. What are the inductance of the coil and the average e.m.f. induced in the coil when this current is reversed in 0.01 second respectively?
The self-inductances of three coils are $L_A = 20\text{ H}$, $L_B = 30\text{ H}$ and $L_C = 40\text{ H}$. The coils are connected in series in such a way that fluxes of $L_A$ and $L_B$ add, fluxes of $L_A$ and $L_C$ are in opposition and fluxes of $L_B$ and $L_C$ are in opposition. If $M_{AB} = 8\text{ H}$, $M_{BC} = 12\text{ H}$ and $M_{AC} = 10\text{ H}$, what is the total inductance of the circuit?
A 100 kVA, 50 Hz single-phase transformer has ratio of secondary to primary turns as 0.1. The secondary voltage at no-load condition is 100 V. What is the value of primary voltage?
A 230 V DC shunt machine has an armature resistance of $0.5\;\Omega$ and a field resistance of $115\;\Omega$. What are the values of e.m.f. induced when the machine acts as a generator and acts as a motor respectively by assuming a line current of 50 A in both the cases?
A 4-pole, three-phase induction motor is supplied from 50 Hz AC supply and the full-load speed of the motor is 1455 r.p.m. What are the values of slip and frequency of the rotor induced e.m.f. at standstill respectively?
The pressurized-water reactor is similar to a boiling-water reactor, except that the coolant water is pumped through the reactor under:
A discharged battery is charged at 6 A for 3 hours after which it is discharged through a resistor of R. If the discharge period is 7 hours and the terminal voltage remains fixed at 12 V, what is the value of R approximately assuming the Ah efficiency of the battery as 85%?
The longest wavelength that can be absorbed by silicon, which has the band gap of 1.12 eV, is $1.1\;\mu\text{m}$. If the longest wavelength that can be absorbed by another material is $0.87\;\mu\text{m}$, then the band gap of this material is approximately:
The band gap of germanium at room temperature is:
Silicon is doped with boron to a concentration of $4 \times 10^{17}\text{ atoms/cm}^3$. Assume the intrinsic carrier concentration of silicon to be $1.5 \times 10^{10}/\text{cm}^3$ and the value of $kT/q$ to be 25 mV at 300 K. Compared to undoped silicon, the Fermi level of doped silicon:
The resistivity of a uniformly doped n-type silicon sample is $0.5\;\Omega\text{-cm}$. If the electron mobility ($\mu_n$) is $1250\text{ cm}^2/\text{V-sec}$ and the charge of an electron is $1.6 \times 10^{-19}\text{ coulomb}$, the donor impurity concentration ($N_D$) in the sample is:
A silicon sample A is doped with $10^{18}\text{ atoms/cm}^3$ of boron. Another sample B of identical dimensions is doped with $10^{18}\text{ atoms/cm}^3$ of phosphorus. The ratio of electron to hole mobility is 3. The ratio of conductivity of the sample A to that of sample B is:
According to the Einstein relation, for any semiconductor, the ratio of diffusion constant to mobility of carriers:
A heavily doped n-type semiconductor has the following characteristics:
Hole-electron mobility ratio: 0.4
Doping concentration: $4.2 \times 10^8\text{ atoms/m}^3$
Intrinsic concentration: $1.5 \times 10^4\text{ atoms/m}^3$
The ratio of conductance of the n-type semiconductor to that of the intrinsic semiconductor of same material and at the same temperature is given by:
A silicon bar is doped with donor impurities $N_D = 2.25 \times 10^{15}\text{ atoms/cm}^3$. Given the intrinsic carrier concentration of silicon at $T = 300\text{ K}$ is $1.5 \times 10^{10}/\text{cm}^3$. Assuming complete impurity ionization, the equilibrium electron and hole concentrations are respectively:
In an open-circuited step-graded junction, the left-half of the bar is p-type with a constant concentration $N_A$, whereas the right-half is n-type with a uniform density $N_D$. In this type of doping, the density changes abruptly from p-type to n-type. What is the contact difference of potential $V_0$?
In a physical diode, there is a component of the reverse saturation current due to leakage over the surface. The reverse saturation current increases approximately 7 percent/°C for both silicon and germanium. The relationship between T and V in V-I characteristics:
Which of the following is correct related to properties of good insulating material?
Which one of the following statements is correct related to long range order in ferromagnets?
Relative static error ($\epsilon_r$) is:
In order to eliminate the effect of temperature variations upon the length of the spring: