Prepare for UPSC Indian Engineering Services (IES/ESE) with verified solutions across Analog & Digital Communications, VLSI & Semiconductor Devices, Signals & Systems, Electromagnetics & Antennas, Microwave Engineering, Control Systems, Computer Organization, and Network Theory.
Marking pattern: +2.00 positive, -0.66 negative (Official UPSC ESE 1/3rd Negative Marking Scheme; 150 Questions, 300 Marks).
The turns ratio of a transformer used in a half-wave rectifier is $n_1 : n_2 = 12 : 1$. The primary is connected to the power mains 220 V, 50 Hz. If the diode resistance in forward bias is zero, the PIV of the diode will be nearly
FET amplifiers are introduced at the initial stages of receivers to make
A JFET has $V_P = -4.5\text{ V}$, $I_{DSS} = 10\text{ mA}$ and $I_{DS} = 2.5\text{ mA}$. The transconductance will be nearly
Which one of the following is not the correct advantage of negative feedback in amplifiers?
The advantage of the dual-slope ADC is its
Consider the following Boolean expression:
$$f = A\overline{B}C + B + B\overline{D} + AB\overline{D} + \overline{A}C$$The simplified expression will be
What is the result of Excess-3 (XS-3) addition of numbers 9 and 5?
The network that couples the output signal voltage of a stage to the input of the next stage of a multi-stage amplifier is called
The expression
$$f = (B + BC)(B + \overline{B}C)(B + D)$$after reduction is equivalent to
PAL is the programmable logic device with a fixed OR array and a programmable AND array. Because only the AND gates are
ROM is a
The characteristic equation of J-K flip-flop is
Which one of the following noise bandwidths is the bandwidth of that ideal bandpass system which produces the same noise power as the actual system?
If an audio signal $s(t) = 3 \cos(2\pi 500t)$ is quantized using 10-bit PCM, the signal-to-quantization noise ratio will be nearly
In information probability, when the base is '2', the unit is a 'bit' and when the base is 'e', the unit is a
An AM broadcast transmitter has a carrier power output of 50 kW. With 80% of modulation, the total power produced will be
A transmitter operates from a 12 V supply with a collector current of 2 A. If the modulation transformer has a turns ratio of 4:1, the load impedance seen by the audio amplifier will be
The fall of $|A_v|$ and the increase of $\theta$ over $180^{\circ}$ with decreasing frequency in the low frequency range are accounted by the
Which one of the following is particularly useful when large amounts of code are needed to handle infrequently occurring cases?
For a Pulse Amplitude Modulated (PAM) transmission of voice signal having maximum frequency equal to 2.5 kHz, if the sampling frequency is 10 kHz and the pulse duration is one-tenth of the sampling period, the transmission bandwidth will be
$S(t)$, the output ASK signal for $kT < t \le (k+1)T$ is
Which of the following statements are correct?
1. A system is said to be linear if it obeys the principle of superposition.
2. A system is said to be linear if it satisfies the homogeneity property.
3. A system is said to be non-linear if it obeys the principle of superposition.
Select the correct answer.
An optical fiber has a bandwidth-distance product of 500 MHz-km. If a bandwidth of 85 MHz is required for a particular mode of transmission, the maximum distance that can be used between repeaters will be nearly
A single-mode fiber has a numerical aperture of 0.15. What is the maximum core diameter it could have for use with infrared light with a wavelength of 820 nm?
Consider the following statements:
A time-invariant system is
1. also referred to equivalently as a shift-invariant system
2. a system for which a time shift or delay of the input sequence causes a corresponding shift in the output sequence
Which of the above statements is/are correct?