Prepare for UPSC Indian Engineering Services (IES/ESE) with verified solutions across Analog & Digital Communications, VLSI & Semiconductor Devices, Signals & Systems, Electromagnetics & Antennas, Microwave Engineering, Control Systems, Computer Organization, and Network Theory.
Marking pattern: +2.00 positive, -0.66 negative (Official UPSC ESE 1/3rd Negative Marking Scheme; 150 Questions, 300 Marks).
A dielectric medium, in which the conduction current is almost non-existent in comparison with the displacement current, may be treated as:
A load of pure resistance of 60 Ω is to be connected through a quarter-wave line to a transmission line of characteristic impedance 100 Ω. If VSWR = 1, the characteristic impedance of the quarter-wave line will be:
A lossless transmission line having characteristic impedance of 600 Ω is terminated by a resistance of 300 Ω. The voltage standing wave ratio in the line will be:
The antenna efficiency $\eta$ (with regards to a radiation resistance) is:
Which one of the following relations is true for an angle of entrance $\theta_{e}$ on the axis of core?
When the cut-off frequency for $\text{TE}_{10}$ mode is 3 GHz, and the value of $v_{0}$ is $3 \times 10^{10}\text{ cm/s}$, the broad wall dimension of a rectangular waveguide will be:
The EM wave of 1 GHz is radiated by an antenna to cover a distance of 100 km. If the velocity of propagation is $3 \times 10^{8}\text{ m/s}$, the time taken by the wave to travel the above distance will be:
The approximate -3 dB beam width for a parabolic antenna in degrees is:
The guide wavelength $\lambda_{g}$ for a cut-off frequency and frequency of operation is:
A broadside array operating at 100 cm wavelength consists of four half-wave dipoles spaced 50 cm. If each element carries radio frequency current in the same phase and of magnitude 0.5 A, and radiation resistance is 73 Ω, the radiated power will be:
Which one of the following, a polycrystalline material of high purity, is the raw material for the preparation of single-crystal silicon?
For a 1000 µm long bond pad locus, the number of bond pads placed on a 100 µm pitch along a bond pad will be:
Which one of the following incorporates both the level sensitivity and the scan path approach using shift registers?
In a reconstruction filter, if the output is $x(t)$ in time domain and $C_{0}X(f)$ in frequency domain with no frequency components above $f_{h}$ and $X(f)$ is 0 (zero) for $|f| \ge f_{h}$, then such signal is called:
Fourier series exists only when the function $f(t)$ is well-defined and single-valued, possesses finite number of discontinuities, and finite number of positive and negative maxima in the period $T$. These conditions are called:
If $X(z) = \frac{1 + \frac{1}{2}z^{-1}}{1 - \frac{1}{2}z^{-1}}$, what is $x(n)$?
A first-order low-pass Butterworth active filter has a cut-off frequency of 10 kHz and unity gain at low frequency. The voltage transfer function magnitude at 12 kHz for the filter will be:
The filters that exhibit symmetry, have an odd-numbered filter length and are used in applications like decimation and interpolation are known as:
The IIR filters involve designing of:
If a pulse sent to the target returns after 15 µs, when the velocity of light is $300 \times 10^{6}\text{ m/s}$, the distance of the target will be:
Pulse Width Modulation (PWM) mode is commonly used in embedded system application for
A chip with fewer transistors results into lower cost, less heat and less power requirements. These features are very desirable in small battery-powered embedded systems such as mobile phones. Which one of the following architectures is used?
Which kind of deposition has traditionally been done at higher temperatures to ensure that all the Si atoms being deposited are incorporated into lattice sites in order to obtain a single-crystal thin film?
Which one of the following layers defines the procedure and functions that physical devices and interfaces have to perform for transmission to occur?
Which one of the following carries multiple voice frequency circuits using either frequency division multiplexed or synchronous time division multiplexed?