Prepare for UPSC Indian Engineering Services (IES/ESE) with official previous years' questions, detailed derivations, phasor analysis, and circuit solutions across Electrical Machines, Power Systems, Control Systems, Power Electronics, Network Theory, and Analog & Digital Circuits.
Marking pattern: +2.00 positive, -0.66 negative (Official UPSC ESE 1/3rd Negative Marking Scheme; 150 Questions, 300 Marks).
If $T_{s}$ represents the shaft torque and $T_{e}$ the electromagnetic torque and if these are assumed positive for a generator, the net torque causing acceleration $T_{a}$ is
Consider the following conditions:
In HVDC transmission, high power factor of the system is maintained for the following reason(s):
Which of the above conditions is/are correct?
Which type of hydro turbine is totally embedded in the fluid and powered from the pressure drop across the device ?
By considering the standard notations, reverse recovery time ($t_{rr}$) of a power diode is
The overdrive factor (ODF) of a power transistor can be expressed as
When the amplitude of the gate pulse to thyristor is increased,
A single-phase full-wave bridge rectifier circuit is fed from a 220 V, 50 Hz supply. It consists of four diodes, a load resistance 20 $\Omega$ and a very large inductance so that the load current is constant. What is the average or dc output voltage?
In a single-phase full-wave controlled bridge rectifier with source inductance and R-L load, the output voltage during overlap is equal to
If a step-down chopper operates in the continuous conduction mode with a duty cycle D, the ripple factor is
When a separately excited dc motor is to be controlled from a 3-phase source for operation in the first quadrant only, which one of the following converters is used?
A wound rotor or slip-ring asynchronous motor is commonly used as drive in overhead cranes and load equalization. Which of the following speed controls is adopted?
Which one of the following statements is correct in a series resonant converter?
Which of the following switching techniques is commonly opted in resonant converters ?
The function of static transfer switch in a multimodular Uninterruptible Power Supply (UPS) system is to change over
Static VAR Compensator (SVC) is usually designed to operate at
What is the spectral efficiency of 16-QAM?
A continuous-time signal is given below :
$$x(t)=8\cos 200\pi t$$
What is the minimum sampling rate required to avoid aliasing?
By considering the standard notations, in DACs, a glitch due to the switch associated with the most significant bit can have an amplitude almost equal to
What is the value of Q factor if the band pass filter is having frequencies from 800 Hz to 1200 Hz?
An AM broadcast radio transfer radiates 10 k Watts of power if modulation percentage is 60. What is the carrier power?
A PLL FM detector uses a VCO with $k_{f}=100\text{ kHz/V}$. If it receives an FM signal with a deviation of 75 kHz and sine-wave modulation, what is the RMS output voltage from the detector?
The signal power and noise power measured at the input of an amplifier are 150 $\mu$W and 1.5 $\mu$W respectively. If the signal power at the output 1.5 W and noise power is 40 mW, what is the amplifier noise factor?
A discrete source emits one of five symbols once every millisecond with probabilities $\frac{1}{2}$, $\frac{1}{4}$, $\frac{1}{8}$, $\frac{1}{16}$ and $\frac{1}{16}$ respectively. What is the source entropy?
According to the description of the AND instruction of 8086 microprocessor, what are the essential conditions to be satisfied while executing it?
What is the modulation index, if the $E_{\text{max}}=150\text{ mV}$ and $E_{\text{min}}=70\text{ mV}$?