Prepare for UPSC Indian Engineering Services (IES/ESE) with official previous years' questions, detailed derivations, phasor analysis, and circuit solutions across Electrical Machines, Power Systems, Control Systems, Power Electronics, Network Theory, and Analog & Digital Circuits.
Marking pattern: +2.00 positive, -0.66 negative (Official UPSC ESE 1/3rd Negative Marking Scheme; 150 Questions, 300 Marks).
A receiver has a noise power bandwidth of 12 kHz. A resistor which matches with the receiver input impedance is conducted across the antenna terminals. What is the noise power contributed by this resistor in the receiver bandwidth ?
(Take temperature as $30^{\circ}\text{C}$)
An amplifier has a bandwidth of 4 MHz with 10 $\text{k}\Omega$ as the input resistor. What is the rms noise voltage at the input to this amplifier if the room temperature is $25^{\circ}\text{C}$?
How many numbers of multiplications is needed in the calculation of FFT with 64 point sequence?
Which one of the following is the correct Butterworth polynomial for second order filter?
Which one of the following is the correct relation of mapping from the 's-plane' to the 'z-plane' in bilinear transformation?
The fundamental period of complex signal $x(t)=e^{j\omega_{0}t}$ is
The energy contained of the signal $x(t)=e^{-2t}u(t)$ is
Which one of the following is a useful property of the unit impulse signal $\delta(t)$?
Which one of the following is correct for the system represented by the relation $y(t)=x(\sin(t)),$ where $x(t)$ and $y(t)$ are input and output respectively?
The Fourier series representations are based on using
What is the Fourier transform of rectangular pulse as shown in the figure below ?
What is the Fourier transform of the function $f(t)=te^{-|t|}$?
What is the signal $x(t)$, based on the following facts:
From the plot shown below, what are the necessary and sufficient conditions for a second order causal LTI discrete time system to be stable?
Statement (I): Diodes designed expressly to operate in the forward biased region are called zener diodes.
Statement (II): The principal operating region for a zener diode is negative in terms of both voltage and current.
Statement (I): A small-signal equivalent circuit of a BJT that applies to both n-p-n and p-n-p transistors is valid at lower frequencies by ignoring capacitance effects.
Statement (II): Despite the structural similarities, a p-n-p BJT has higher current gain than a comparable n-p-n BJT because holes are less mobile than electrons.
Statement (I): MOSFETs are preferred over JFETs for digital integrated circuits, either p-channel metal-oxide semiconductor or n-channel metal-oxide semiconductor logic circuits can be constructed.
Statement (II): The usage of a p-channel MOSFET as the active load for an n-channel MOSFET leads to a logic family known as complementary-symmetry MOS or CMOS.
Statement (I): A system is LTI if and only if there exists a signal, called the system unit impulse response.
Statement (II): The output of a discrete-time LTI system is equal to the convolution sum between the input signal and its unit impulse response.
Statement (I): The root locus is the path of the roots of the characteristic equation traced out in the s-plane as a system parameter varies from zero to infinity.
Statement (II): The frequency response of a system is defined as the steady-state response of the system to a non-sinusoidal unique input signal, and the resulting output signal for a linear system is sinusoidal in the steady-state; it differs from the input only in amplitude and phase angle.
Statement (I): Transformers take advantage of the high magnetic energy density of ferromagnetic material to allow economical device design, however, the non-linear nature of ferromagnetic material leads to introduction of harmonics in current or voltage.
Statement (II): The non-linear nature of the transformer magnetizing inductance can lead to a transient inrush current significantly greater than the rated value of current upon energizing a transformer.
A transistor has $\beta=105$ and $I_{C}=840\ \mu\text{A}$. What is the value of $I_{B}$?
What is the power gain of a transistor amplifier, if its current gain is 40 and voltage gain is 25?
Which one of the following statements is not correct regarding common-base amplifier?
When the quiescent point of an amplifier is biased just at the cut-off axis, so that only the positive half of the signal input is amplified and the negative half of the signal is cut off, it is referred to as
Which one of the following is a disadvantage of CE amplifier?