Prepare for UPSC Indian Engineering Services (IES/ESE) with verified solutions across Analog & Digital Communications, VLSI & Semiconductor Devices, Signals & Systems, Electromagnetics & Antennas, Microwave Engineering, Control Systems, Computer Organization, and Network Theory.
Marking pattern: +2.00 positive, -0.66 negative (Official UPSC ESE 1/3rd Negative Marking Scheme; 150 Questions, 300 Marks).
Which one of the following adders divides the full adder into groups and employs carry bypass logic to speed up the carry propagation?
Number of flip-flops needed to design a twisted-ring counter (SN7400 series), that has ten unique states, is
Match the following lists
| List-I | List-II |
|---|---|
| P. Format control | 1. NAK, ETB |
| Q. Transmission control | 2. RS, US |
| R. Information separator | 3. EM, DC1, DC2, DC3, DC4 |
| S. Miscellaneous | 4. FF, VT |
Select the correct answer using the code given below:
Common error control techniques are not based on
Match the following lists:
| List-I | List-II |
|---|---|
| P. SCMA | 1. Interleavers are used as the only means for user separation |
| Q. MC-CDMA | 2. Applies a new set of spreading codes that exhibit interference free window to separate users in the wireless channel |
| R. IDMA | 3. Enables two or more users, associated with the same base station, to use the same time and frequency and code resources on the grounds of their physical location or spatial separation |
| S. LAS-CDMA | 4. Spreads each user symbol in the frequency domain |
Select the correct answer using the code given below:
Which one of the following is not the property of WiseMAC?
A cell-site transmitter generates + 15 dBm RF signal and is connected to an antenna using an RF coaxial cable that induces a 3 dB loss. The cable has two connectors at its either end that induce a loss of 2 dB each. What is the signal level at the input of the antenna?
Which one of the following is not the property of flooding?
Which one of the following is a disadvantage of CDMA?
Which one of the following statements is correct for ST connector?
Network and switching subsystem does not have which one of the following switches and databases?
Which one of the following statements is not correct about the D-channel contention-resolution algorithm?
Which one of the following is not an advantage of a WLAN ?
Consider the following statements:
1. The VLSI circuit (all the devices and their interconnections) is fabricated on a die. In a single wafer, there are always two dies. The complete one VLSI circuit is equally distributed (fabricated) on each die.
2. Modern technologies use a diamond saw to separate the dies from the wafer.
3. A suitable compound material is used to package the die to provide protection to the die from environmental damage, to prevent the interface to the outside world, to provide the cooling of heat generated due to power dissipation.
Which of the above statements are not correct?
Consider the following statements:
1. Programmable Logic Array (PLA) is a programmable logic device with AND array followed by the OR array, where the AND array is programmable but the OR array is fixed.
2. Additional input in PLA does not require doubling the size of AND and OR array. Therefore, PLA is cheaper than Programmable Array Logic (PAL).
3. PLA is more flexible as compared to PAL and Read Only Memory (ROM).
4. PLA, PAL and ROM can be used to implement sum of product (SOP) with any number of terms.
Which of the above statements is/are correct?
The power transmitted by an SSB transmitter is 20 kW. It is required to be replaced by standard AM transmission having modulation index of 0.4 and same power. What is the transmission efficiency?
An angle modulated signal is given as $x_c(t) = 20 \cos\left[200\pi t + \frac{\pi}{4}\right]$. What is the instantaneous frequency?
An FM modulator operates at carrier frequency of 250 kHz with frequency deviation sensitivity of 1.5 kHz/V. A PM modulator operates at carrier frequency of 500 kHz with phase deviation sensitivity of 1.5 rad/V. If both FM and PM modulators are modulated by the same modulating signal having peak amplitude of 5 V and modulating frequency of 5 kHz, then what is the relationship between frequency modulation index and phase modulation index?
What is the relationship between the percentage efficiency saving when the carrier wave and one of the sidebands are suppressed in an AM wave modulated to a depth of 100% modulation index?
An audio signal $s(t) = 5 \cos(2000\pi t)$ is quantized using 10-bit PCM. What is the signal-to-quantization noise ratio?
An FM audio signal with single-tone modulation has a frequency deviation of 25 kHz and a bandwidth of 75 kHz. What is the frequency of the modulating signal using Carson's rule?
An audio signal $s(t)$ is normalized, whose Fourier transform $S(f)$ is shown in the figure, so that $|s(t)| \le 1$. This signal is to be transmitted using FM with a frequency deviation constant $k_f = 90\text{ kHz/V}$. What is the bandwidth required for transmission of the FM audio signal?
A collector modulated class-C power amplifier is giving an amplitude modulated signal of 220 W average power at the output, while operating with a collector circuit efficiency of 40%. What is the power to be supplied by the modulating amplifier when the modulation index is 0.4?
By considering standard notations, the normalized power of the AM signal is:
A certain AM transmitter is radiating 125 kW when a certain audio sine wave is modulating it to a depth of 70% and 144.5 kW when a second sinusoidal audio wave also modulates it simultaneously. What is the depth of the modulation for the second audio wave?